Absence of Relevant Thermal Conversion of Cannabidiol to Tetrahydrocannabinol in E-Cigarette Vapor and Low-Tetrahydrocannabinol Cannabis Smoke.

Introduction: Recent research claimed that CBD in commercial electronic cigarette (e-cigarette) liquids can be converted into psychotropic amounts of Δ9-THC. This study aims to validate this claim using a realistic e-cigarette setup. In addition, this study also investigates if such a conversion may occur during smoking of CBD-rich cannabis joints. Materials and Methods: Two different CBD liquids were vaporized using two different e-cigarette models, one of which was operated at extreme energy settings (0.2 Ω and 200 W). The smoke of six CBD joints was collected using a rotary smoking machine according to ISO 4387:2019. Analyses were conducted using nuclear magnetic resonance spectrometry as well as liquid chromatography tandem mass spectrometry. Results: For the condensed e-cigarette liquids, no increase in THC concentration could be observed. For the CBD joints, no THC formation was provable. The recovered THC concentrations were ranging between 1% and 48% (0.034 and 0.73 mg) of the THC amount initially contained in the joints before smoking. Conclusions: Using realistic conditions of consumer exposure, relevant conversion of CBD to THC appears to not be occurring. The health risk of CBD liquids for e-cigarettes, as well as low-THC cannabis intended for smoking, can be assessed by concentrations in the source material without the need to consider significant changes in psychotropic compounds during use by consumers.

Using the BMD Approach to Derive Acceptable Daily Intakes of Cannabidiol (CBD) and Tetrahydrocannabinol (THC) Relevant to Electronic Cigarette Liquids.

BACKGROUND: In the past 60 years, Cannabis sativa L. has been an object of increasing interest because of the psychotropic effects of some of its constituents. These effects mainly arise from the cannabinoid Δ9-tetrahydrocannabinol (Δ9-THC). C. sativa species also synthesize and accumulate the non-psychotropic compound cannabidiol (CBD). Due to their therapeutic potential, both cannabinoids are an object of medical research and drug development. More recently, CBD has received increasing interest as an ingredient in electronic cigarette liquids (e-liquids). This trend may have been reinforced by health and disease-related claims, often based on clinical studies, which are used to advertise CBD. CBD liquids may be based on full-spectrum hemp extracts, CBD isolates, or synthetic CBD, all of which may contain some residual levels of Δ9-THC from either natural content (in the extracts) or from possible degradation of CBD to Δ9-THC, which may occur during storage. There is uncertainty about safety regarding the consumption of CBD (and Δ9-THC) in e-liquids. The aim of this publication was to present an approach for a toxicological risk assessment of CBD and Δ9-THC relevant to e-liquids by using the benchmark dose (BMD) approach. MATERIALS AND METHODS: Before an analysis to estimate a reference dose (RfD) for both cannabinoids, a systematic review of dose-response data was conducted. The data obtained were analyzed using the BMD approach to derive a benchmark dose lower confidence limit (BMDL). The BMDL was used as a point of departure to estimate the RfD. RESULTS: No adequate human data suitable for dose-response modeling were identified. Based on animal data, the RfD values for the most sensitive endpoints were selected. For CBD, an RfD for acute exposure of 1 mg/kg body weight (bw) was estimated. For Δ9-THC, an acute RfD was found to be 0.006 mg/kg bw. Additionally, the RfD for chronic exposure to CBD was estimated to be 4 mg/kg bw per day. The respective endpoints for CBD were a reduction in norepinephrine turnover and a reduction in uterus weight. The endpoint for Δ9-THC was a change in blood pressure. CONCLUSIONS: Because of the limited availability and quality of dose-response data, it cannot be excluded that the estimated RfD values might be afflicted with considerable uncertainties. Therefore, it is recommended to conduct further research on dose-response data, preferably from human studies.

Absorption Coefficients of Phenolic Structures in Different Solvents Routinely Used for Experiments.

Phenolic structures are of great interest due to their antioxidant properties and various postulated benefits on human health. However, the quantification of these structures in fruits and vegetables, as well as in vivo or in vitro experiments, is demanding, as relevant concentrations are often low, causing problems in exactly weighing the respective amounts. Nevertheless, the determination of used concentrations is often a prerequisite for accurate results. A possibility to quantify polyphenol is the use of UV/vis spectroscopy. Therefore, the absorption coefficients of selected phenolic structures were determined in three different solvents relevant for polyphenol research (water/methanol (50/50, v/v), water, and phosphate buffer at pH 7.5). To confirm the values based on weight and to avoid errors due to impurities, hygroscopic effects, and inadequate balance care, the mass concentrations were additionally determined by quantitative NMR (q-NMR). The coefficients presented in this article can help to quickly and easily determine accurate concentrations in a laboratory routine without wasting the often-precious standard compounds.

A Quantitative 1H NMR Method for Screening Cannabinoids in CBD Oils.

Toxicologically relevant levels of the psychoactive ∆9-tetrahydocannabinol (∆9-THC) as well as high levels of non-psychoactive cannabinoids potentially occur in CBD (cannabidiol) oils. For consumer protection in the fast-growing CBD oil market, facile and rapid quantitative methods to determine the cannabinoid content are crucial. However, the current standard method, i.e., liquid chromatography combined with tandem mass spectrometry (HPLC-MS/MS), requires a time-consuming multistep sample preparation. In this study, a quantitative nuclear magnetic resonance spectroscopy (qNMR) method for screening cannabinoids in CBD oils was developed. Contrary to the HPLC-MS/MS method, this qNMR features a simple sample preparation, i.e., only diluting the CBD oil in deuterochloroform. Pulse length-based concentration determination (PULCON) enables a direct quantification using an external standard. The signal intensities of the cannabinoids were enhanced during the NMR spectra acquisition by means of multiple suppression of the triglycerides which are a major component of the CBD oil matrix. The validation confirmed linearity for CBD, cannabinol (CBN), ∆9-THC and ∆8-THC in hemp seed oil with sufficient recoveries and precision for screening. Comparing the qNMR results to HPLC-MS/MS data for 46 commercial CBD oils verified the qNMR accuracy for ∆9-THC and CBD, but with higher limits of detection. The developed qNMR method paves the way for increasing the sample throughput as a complementary screening before HPLC-MS/MS.

Cold Brew Coffee-Pilot Studies on Definition, Extraction, Consumer Preference, Chemical Characterization and Microbiological Hazards.

Cold brew coffee is a new trend in the coffee industry. This paper presents pilot studies on several aspects of this beverage. Using an online survey, the current practices of cold brew coffee preparation were investigated, identifying a rather large variability with a preference for extraction of medium roasted Arabica coffee using 50-100 g/L at 8 °C for about 1 day. Sensory testing using ranking and triangle tests showed that cold brew may be preferred over iced coffee (cooled down hot extracted coffee). Extraction experiments under different conditions combined with nuclear magnetic resonance (NMR) analysis showed that the usual extraction time may be longer than necessary as most compounds are extracted within only a few hours, while increasing turbulence (e.g., using ultrasonication) and temperature may additionally increase the speed of extraction. NMR analysis also revealed a possible chemical differentiation between cold brew and hot brew using multivariate data analysis. Decreased extraction time and reduced storage times could be beneficial for cold brew product quality as microbiological analysis of commercial samples detected samples with spoilage organisms and contamination with Bacillus cereus.

Rapid Approach to Determine Propionic and Sorbic Acid Contents in Bread and Bakery Products Using 1H NMR Spectroscopy.

The food additive sorbic acid is considered as an effective preservative for certain cereal products, and propionic acid is commonly added in bakery wares, e.g., bread and fine bakery wares. The aim of this study was to develop and validate a new nuclear magnetic resonance spectroscopy (1H NMR) method for the routine screening and quantification of sorbic and propionic acids in bread and several bakery products for quality control purposes. Results showed that none of the screened samples contained higher concentrations than regulatory maximum limits. However, for some samples, labelling of preservatives was lacking or they were used in food categories, for which the use is not approved. It can be concluded that the developed NMR method can be used for the routine screening of bakery products.

Fully Automated Identification of Coffee Species and Simultaneous Quantification of Furfuryl Alcohol Using NMR Spectroscopy.

BACKGROUND: Coffee is a popular beverage with two species, Coffea canephora and C. arabica, being commercially exploited. The quality and commercial value of coffee is dependent on species and processing. C. arabica typically obtains a higher price on the market compared to C. canephora. Coffee beans undergo roasting during processing, resulting in the formation of flavor compounds including furfuryl alcohol which has been classified by the International Agency for Research on Cancer as possibly carcinogenic to humans (Group 2B). OBJECTIVE: The aim of this study was to identify coffee species and other properties using nuclear magnetic resonance (NMR) spectroscopy, specifically to conduct quantification of the roasting process contaminant furfuryl alcohol. METHOD: The quantification of furfuryl alcohol was performed from the NMR spectra using the pulse length-based concentration (PULCON) methodology. Prior to NMR analysis, samples were extracted using deuterated chloroform. RESULTS: Roasting experiments identified the maximum roasting temperature to be the most significant factor in the formation of furfuryl alcohol. Among the coffee species, C. canephora was found to contain a relatively lower amount of furfuryl alcohol compared to C. arabica. The roasting of wet processed coffee resulted in higher contents of furfuryl alcohol. Geographical origin and variety within species had no influence on the furfuryl alcohol content. CONCLUSION: Validation results show that NMR spectroscopy is fit-for-purpose to obtain targeted information of coffee samples. HIGHLIGHTS: The PULCON NMR methodology allows a simple, rapid and accurate determination of constituents of coffee.

Application of 1H Nuclear Magnetic Resonance Spectroscopy as Spirit Drinks Screener for Quality and Authenticity Control.

Due to legal regulations, the rise of globalised (online) commerce and the need for public health protection, the analysis of spirit drinks (alcoholic beverages >15% vol) is a task with growing importance for governmental and commercial laboratories. In this article a newly developed method using nuclear magnetic resonance (NMR) spectroscopy for the simultaneous determination of 15 substances relevant to assessing the quality and authenticity of spirit drinks is described. The new method starts with a simple and rapid sample preparation and does not need an internal standard. For each sample, a group of 1H-NMR spectra is recorded, among them a two-dimensional spectrum for analyte identification and one-dimensional spectra with suppression of solvent signals for quantification. Using the Pulse Length Based Concentration Determination (PULCON) method, concentrations are calculated from curve fits of the characteristic signals for each analyte. The optimisation of the spectra, their evaluation and the transfer of the results are done fully automatically. Glucose, fructose, sucrose, acetic acid, citric acid, formic acid, ethyl acetate, ethyl lactate, acetaldehyde, methanol, n-propanol, isobutanol, isopentanol, 2-phenylethanol and 5-(hydroxymethyl)furfural (HMF) can be quantified with an overall accuracy better than 8%. This new NMR-based targeted quantification method enables the simultaneous and efficient quantification of relevant spirit drinks ingredients in their typical concentration ranges in one process with good accuracy. It has proven to be a reliable method for all kinds of spirit drinks in routine food control.

Impact of B-Ring Substitution and Acylation with Hydroxy Cinnamic Acids on the Inhibition of Porcine α-Amylase by Anthocyanin-3-Glycosides.

An inhibitory effect on α-amylase and α-glucosidase is postulated for polyphenols. Thus, ingestion of those secondary plant metabolites might reduce postprandial blood glucose level (hyperglycemia), which is a major risk factor for diabetes mellitus type II. In addition to a previous study investigating structure-effect relationships of different phenolic structures, the effect of anthocyanins is studied in detail here, by applying an α-amylase activity assay, on the basis of the conversion of 2-chloro-4-nitrophenyl-4-O-ß-galactopyranosyl maltoside (GalG2CNP) and detection of CNP release by UV/Vis spectroscopy and isothermal titration calorimetry (ITC). All anthocyanin-3-glucosides showed a mixed inhibition with a strong competitive proportion, Kic < 134 µM and Kiu < 270 µM; however, the impact of the B-ring substitution was not statistically significant. UV/Vis detection failed to examine the inhibitory effect of acylated cyanidins isolated from black carrot (Daucus carota ssp. Sativus var. Autrorubens Alef.). However, ITC measurements reveal a much stronger inhibitory effect compared to the cyanidin-3-glucoside. Our results support the hypothesis that anthocyanins are efficient α-amylase inhibitors and an additional acylation with a cinnamic acid boosts the observed effect. Therefore, an increased consumption of vegetables containing acylated anthocyanin derivatives might help to prevent hyperglycemia.

Validation of a Quantitative Proton Nuclear Magnetic Resonance Spectroscopic Screening Method for Coffee Quality and Authenticity (NMR Coffee Screener).

Monitoring coffee quality as a means of detecting and preventing economically motivated fraud is an important aspect of international commerce today. Therefore, there is a compelling need for rapid high throughput validated analytical techniques such as quantitative proton nuclear magnetic resonance (NMR) spectroscopy for screening and authenticity testing. For this reason, we sought to validate an 1H NMR spectroscopic method for the routine screening of coffee for quality and authenticity. A factorial experimental design was used to investigate the influence of the NMR device, extraction time, and nature of coffee on the content of caffeine, 16-O-methylcafestol (OMC), kahweol, furfuryl alcohol, and 5-hydroxymethylfurfural (HMF) in coffee. The method was successfully validated for specificity, selectivity, sensitivity, and linearity of detector response. The proposed method produced satisfactory precision for all analytes in roasted coffee, except for kahweol in canephora (robusta) coffee. The proposed validated method may be used for routine screening of roasted coffee for quality and authenticity control (i.e., arabica/robusta discrimination), as its applicability was demonstrated during the recent OPSON VIII Europol-Interpol operation on coffee fraud control.